6/10/2023 0 Comments Odometer error message vwReinstall driver’s-side seat (refer to the applicable Subaru Service Manual).Secure the TPMS wiring harness to the harness that runs vertically to the cross member.Wrap all of the wires with electrical tape to the harness.when the circuit is complete you get 60, when only half is there, you get 120. The communications are a 2 wire high/low split that is a complete circle with a resistor at each end. Wrap each wire with electrical tape at least two times, making sure to protect each wire from shorting or grounding. It will do nothing till you get 60 ohms across 6 and 14.Cut the eight wires as closely as possible to the R211 connector.Turn the wiring harness insulation back by 2” (50 mm) at the R211 connector and cut it off. VW Passat flashing glow plug light The glow plugs light flashing is an indication of a fault with the engine management system. Locate the TPMS wiring harness and R211 connector (white, 12 pin).Move the carpet out of the way to gain access to the wiring harness and connector.Remove the driver’s side seat (refer to the applicable Subaru Service Manual).Disconnect the negative battery terminal.The R211 wiring harness and connector was eliminated on 2006 Legacy and Outback vehicles, with the exception to 3.0 H-6 Models, starting in Dec. Other errors to look for on your certificate include incorrect car colour, make, model, or class. If the connector comes in contact with moisture and corrosion forms, the BIU (Body Integrated Unit) may judge a speed pulse malfunction and, in turn, display error code “Er SP.” To correct this condition, refer to the repair procedure listed.
0 Comments
Leave a Reply. |